Inspection Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect the manifold for the following conditions:
- Damaged gasket or sealing surfaces
- Loose threaded inserts or studs
- Debris or restrictions within the passages of the manifold
- Damaged or broken vacuum fittings
- Inspect the composite intake manifold assembly for cracks or other damage.
- Inspect the intake manifold cylinder head deck for warpage.
- Locate a straight edge across the intake manifold cylinder head deck surface.
Position the straight edge across a minimum of two runner port openings.
- Insert a feeler gage between the intake manifold and the straight edge.
An intake manifold with warpage in excess of 3 mm (0.118 in) over a 200 mm (7.87 in) area is warped and should be replaced.
- Locate a straight edge across the intake manifold cylinder head deck surface.