LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 161 (Engine Mechanical - 4.8L, 5.3L, 6.0L And 6.2L (4 Of 5)) >> Off-Vehicle Repair Instructions (2 Of 3) >> Intake Manifold Cleaning and Inspection >> Cleaning Procedure

Cleaning Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Intake Manifold-To-Cylinder Head Gasket
    GM1277097Courtesy of GENERAL MOTORS CORP.
  1. Remove and discard the intake manifold-to-cylinder head gaskets (514).
    2. Fig 2: View Of Intake Manifold
    GM1401989Courtesy of GENERAL MOTORS CORP.
  2. Remove the manifold absolute pressure (MAP) sensor (714). Refer to Intake Manifold Removal (RPO LY2/LY6) or Intake Manifold Removal (RPO LC9/LY5/LMG/L76) or Intake Manifold Removal (RPO L92) .
  3. Remove the evaporative emission (EVAP) canister purge solenoid valve, EVAP tubes, and fuel rail with injectors. Refer to Fuel Rail and Injectors Removal .
  4. Remove the throttle body and gasket. Refer to Throttle Body Removal .
  5. Clean the intake manifold (500) in solvent.
    6. CAUTION: Refer to Safety Glasses and Compressed Air Caution .
  6. Dry the intake manifold with compressed air.
scientia non olet · About LEMON Manuals