Installation Procedure
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
- Fasten the screws that hold the speaker to the quarter trim panel.
Tighten: Tighten screws/bolts to 2 N.m (18 lb in).
- Install the speaker grille.
- Make the electrical connection to the speaker harness.
- Install the rear quarter panel to the body. Refer to Body Side Trim Panel Replacement - Right Side or Body Side Trim Panel Replacement - Left Side .
- Check speaker for operation.
NOTE:
Refer to Fastener Notice
.