Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Door Speaker

Courtesy of GENERAL MOTORS CORP.

Install the speaker to the vehicle.
Connect the electrical connector to the speaker.

NOTE: Refer to Fastener Notice .

Install the bolts retaining the speaker mounting bracket to the door.
Tighten: Tighten the bolts to 6 N.m (53 lb in).
Install the door trim panel. Refer to Rear Side Door Trim Panel Replacement .
Verify the component operation.