Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: GPS Antenna

Courtesy of GENERAL MOTORS CORP.

Install the GPS antenna (2) to the I/P bracket.
Route the GPS antenna cable to the radio opening, as noted in the removal procedure.
Slide the GPS antenna (2) toward the driver side of vehicle and align the screw hole.

NOTE: Refer to Fastener Notice .

Install the screw (1).
Tighten: Tighten the screw (1) to 2 N.m (18 lb in).
Install the radio. Refer to Radio Replacement .
Install the I/P top pad. Refer to Instrument Panel Upper Trim Pad Replacement .