LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Cellular, Entertainment, And Navigation) >> Repair Instructions >> Fixed Antenna Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Antenna Base Screws (1), Antenna Base (2)
    GM1440896Courtesy of GENERAL MOTORS CORP.
  1. Attach the mechanics wire or string, used during removal, to the replacement antenna base/cable (2).
  2. Seat the body pass through grommet.
    3. NOTE: Refer to Fastener Notice .
  3. Install the antenna base screws (1).

    Tighten:  Tighten the screw to 7.5 N.m (71 lb in).

    4. Fig 2: Antenna Mast
    GM1440893Courtesy of GENERAL MOTORS CORP.
  4. Connect the cable to the I/P extension cable.
  5. Install the passenger kick panel. Refer to Front Floor Kick-Up Panel Replacement .
  6. Install the intake air duct.
  7. Install the intake air duct screws.

    Tighten:  Tighten the screws to 1.6 N.m (14 lb in).

  8. Install the antenna mast.
  9. Seat the antenna mast boot.
scientia non olet · About LEMON Manuals