LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Cellular, Entertainment, And Navigation) >> Repair Instructions >> Digital Radio Antenna Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Use care when removing or installing the headliner. Excessive bending will damage the headliner.
    Fig 1: View Of Antenna Base & Cables
    GM853340Courtesy of GENERAL MOTORS CORP.
  1. Lower the front of the headliner. Refer to Headlining Trim Panel Replacement .
  2. Disconnect the antenna cable from the antenna.
    3. IMPORTANT: Note the antenna cable routing, clip and tape location during dis-assembly in order to route the cable back to factory routing.
  3. Release the antenna cable from the cable clips above the headliner and the windshield pillar.
  4. Remove the passenger side kick up panel. Refer to Front Floor Kick-Up Panel Replacement .
  5. Remove the XM radio receiver, if equipped. Refer to Digital Radio Receiver Replacement .
  6. Disconnect the antenna cable harness from the Instrument Panel (IP) harness.
  7. Release the antenna cable from the hold down clips and tape below the IP.
  8. Tie a piece of string or mechanics wire to the antenna cable harness end below the IP.
    9. Fig 2: Locating Antenna Cable
    GM1207705Courtesy of GENERAL MOTORS CORP.
  9. Carefully pull the cable end out from behind the IP and above the top pad.
  10. Leaving the string/mechanics wire in place behind the IP and disconnect the wire/string from the antenna cable.
  11. Release the antenna cable from the cable clips.
  12. Remove the antenna cable from the vehicle.
scientia non olet · About LEMON Manuals