Installation Procedure
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
- Route the antenna cable above the headliner.
- Connect the antenna cable to the antenna.
- Secure the cable to the roof, above the headliner as noted during disassembly.
- Attach the mechanics wire or string, used during removal, to the end of the antenna cable.
- Carefully pull the antenna cable past the top pad to below the IP.
- Secure the antenna cable to windshield pillar area and below the IP as noted during disassembly.
- Connect the antenna cable to the IP harness.
- Install the XM radio receiver, if equipped. Refer to Digital Radio Receiver Replacement .
- Install the passenger side kick up panel. Refer to Front Floor Kick-Up Panel Replacement .
- Install the headliner. Refer to Headlining Trim Panel Replacement .