LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Cellular, Entertainment, And Navigation) >> Repair Instructions >> Antenna Replacement - Cellular Communications/Digital Radio >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Antenna Base & Cables
    GM853340Courtesy of GENERAL MOTORS CORP.
    NOTE: DO NOT apply paint or clear coat to the antenna. This will damage the function of the antenna, causing poor reception or loss of signal reception.
  1. Remove the windshield garnish molding. Refer to Windshield Pillar Garnish Molding Replacement .
  2. Remove the sunshade from the headliner. Refer to Sunshade Replacement .
  3. Remove the lock pillar trim. Refer to Body Lock Pillar Trim Panel Replacement .
    4. IMPORTANT: Complete removal of the headliner is not required.
  4. Lower the front corner of the headliner. Refer to Headlining Trim Panel Replacement .
    5. Fig 2: Identifying Retaining Nut Of Antenna Assembly
    GM838978Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the wire harness to the roof antenna.
  6. Remove the antenna fastener.
  7. Remove the antenna from the roof.
scientia non olet · About LEMON Manuals