LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Cellular, Entertainment, And Navigation) >> Repair Instructions >> Antenna Replacement - Cellular Communications/Digital Radio >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Antenna Base & Cables
    GM853340Courtesy of GENERAL MOTORS CORP.
  1. Attach the antenna base to the roof.
  2. Install the retainer and bolt to the antenna.
    NOTE: Refer to Fastener Notice .

    Tighten:  Tighten the bolt to 9 N.m (80 lb in).

    3. Fig 2: Identifying Retaining Nut Of Antenna Assembly
    GM838978Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connector to the antenna.
  4. Position the headliner back to the roof. Refer to Headlining Trim Panel Replacement .
  5. Install the sunshade to the headliner. Refer to Sunshade Replacement .
  6. Install the windshield garnish molding. Refer to Windshield Pillar Garnish Molding Replacement .
  7. Install the lock pillar trim. Refer to Body Lock Pillar Trim Panel Replacement .
scientia non olet · About LEMON Manuals