Mast Antennas

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Unplug the antenna lead-in connector from the radio receiver and plug a test antenna into the radio. Make sure the antenna base is grounded to the vehicle chassis and keep hands off the mast.

Check the radio reception in an area away from electrical interferences. Tune to several weak and strong AM and FM stations. If the radio reception improved, the problem exists with the antenna and/or lead-in cable. If the reception is still poor, refer to Audio System Troubleshooting Hints .

IMPORTANT: Always zero out the DMM before taking a resistance measurement in order to ensure an accurate reading.

Fig 1: Identifying Mast Antenna System Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Negative Battery Cable
2	Coaxial Cable Conductor - Radio End
3	Coaxial Cable Metal Outer Shield - Radio End
4	Coaxial Cable Metal Outer Shield - Antenna End
5	Coaxial Cable Conductor - Antenna End
6	Antenna Base
7	Antenna Mast
8	Antenna Coaxial Cable

Radio Poor Reception

Ohmmeter Probes At Points	Resistance Measured In Ohms
1 and 3	Less than 0.2
1 and 4	Less than 0.2
1 and 6	Less than 0.2
1 and 2	Infinite
1 and 5	Infinite
1 and 7	Infinite
2 and 3	Infinite
2 and 4	Infinite
2 and 6	Infinite
3 and 4	Less than 0.2
3 and 6	Less than 0.2
3 and 5	Infinite
3 and 7	Infinite

Refer to the table when testing the antenna and/or lead-in cable.

Measure the resistance from the coax center conductor to antenna mast.
Total resistance from end to end of center conductor:
- RG-58/RG-59 type cable-Less than 0.2 ohms
- RG-62/RG-62M type cable-Less than 3.5 ohms
When checking the resistance, cautiously wiggle the lead-in tip and cable. Refer to Testing for Intermittent Conditions and Poor Connections .
Measure the resistance from the cable center conductor to metal case.
Replace the antenna and/or lead-in cable when the above readings are not obtained.

Some vehicles come equipped with a pre-amplified AM/FM antenna that is powered by SW 12+. If the antenna loses this power source or a ground, poor reception can occur. To see if your vehicle is equipped with a pre-amplified antenna, refer to Radio/Navigation System Schematics .