Test Description
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
The numbers below refer to the step numbers on the diagnostic table.
- 2: This step verifies that the DTC is still present.
- 3: This step isolates the fault condition.
DTC B1025, B1035, B1045, or B1055
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Radio/Navigation System Schematics Connector End View Reference: Entertainment/Communication Connector End Views |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 |
|
Go to Step 3 | Go to Testing for Intermittent Conditions and Poor Connections |
| 3 | Test the speaker outputs from the radio for a short to ground or voltage. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
Go to Step 6 | Go to Step 4 |
| 4 | Inspect for poor connections at the harness connector of the radio. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
. Did you find and correct the condition? |
Go to Step 6 | Go to Step 5 |
| 5 | Replace the radio. Refer to Control Module References
. Did you complete the replacement? |
Go to Step 6 | - |
| 6 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |