LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 158 (Rear Suspension System) >> Repair Instructions >> Wheel Stud Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  3. Remove the brake rotor. Refer to Rear Brake Rotor Replacement (1500 Series) or Rear Brake Rotor Replacement (2500 Series) .
    4. Fig 1: Using Ball Joint Remover J 43631
    GM361843Courtesy of GENERAL MOTORS CORP.
  4. Remove the wheel stud from the hub flange using the J 43631  .
  5. Remove the wheel stud from the hub flange.
scientia non olet · About LEMON Manuals