LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 158 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the stabilizer shaft insulators.
    2. Fig 1: View Of Stabilizer Shaft Insulator Bracket Mounting Bolts (15/25 Series)
    GM582397Courtesy of GENERAL MOTORS CORP.
  2. Install the stabilizer shaft.
  3. Install the stabilizer shaft insulator brackets to the rear axle.
  4. Install the stabilizer shaft bracket mounting bolts.
    5. Fig 2: View Of Stabilizer Shaft Bracket Mounting Bolts (15/25 Series)
    GM613612Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
    IMPORTANT: When tightening the lower link nut verify that the inner jam nut bottoms out on the ball stud.
  5. Install the stabilizer shaft link nut to the ball stud.

    Tighten: 

    1. Tighten the ball stud to stabilizer shaft nut to 75 N.m (55 lb ft).
    2. Tighten the insulator bracket bolts to 33 N.m (24 lb ft).

  6. Lower the vehicle.
scientia non olet · About LEMON Manuals