LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 158 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Link Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Stabilizer Shaft Link Nut & Ball Stud (15/25 Series)
    GM545533Courtesy of GENERAL MOTORS CORP.
  1. Install the stabilizer shaft link.
    2. IMPORTANT: When tightening the lower link nut, verify that the inner jam nut bottoms out on the ball stud. To ensure that the nut does not back away during the tightening process, hold the stud with the appropriate tool.
    Fig 2: View Of Stabilizer Shaft Bracket Mounting Bolts (15/25 Series)
    GM613612Courtesy of GENERAL MOTORS CORP.
  2. Install the stabilizer shaft link nut to the ball stud.
    3. Fig 3: View Of Stabilizer Shaft Link Nut & Ball Stud (15/25 Series)
    GM545533Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the stabilizer shaft link nut and bolt to the frame bracket.

    Tighten: 

    1. Tighten the link to frame bracket nut to 75 N.m (55 lb ft).
    2. Tighten the ball stud to stabilizer shaft nut to 75 N.m (55 lb ft).

  4. Lower the vehicle.
scientia non olet · About LEMON Manuals