LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 158 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Insulator Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. Fig 1: View Of Stabilizer Shaft Insulator Bracket Mounting Bolts (15/25 Series)
    GM582397Courtesy of GENERAL MOTORS CORP.
  2. Remove the stabilizer shaft insulator bracket mounting bolts.
  3. Remove the stabilizer shaft insulators brackets.
  4. Lower the stabilizer shaft and remove the stabilizer shaft insulators.
  5. Inspect all of the parts for wear or damage.
scientia non olet · About LEMON Manuals