LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 158 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Insulator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Place the stabilizer shaft insulators on the stabilizer bar with the slits facing toward the front of the vehicle.
    Fig 1: View Of Stabilizer Shaft Insulator Bracket Mounting Bolts (15/25 Series)
    GM582397Courtesy of GENERAL MOTORS CORP.
  1. Install the stabilizer shaft insulators to the stabilizer bar.
  2. Install the stabilizer shaft insulator brackets to the rear axle.
    3. NOTE: Refer to Fastener Notice .
  3. Install the stabilizer shaft bracket mounting bolts.

    Tighten:  Tighten the insulator bracket bolts to 33 N.m (24 lb ft).

  4. Lower the vehicle.
scientia non olet · About LEMON Manuals