LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 158 (Rear Suspension System) >> Repair Instructions >> Shock Absorber Replacement (1500 Series) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. Fig 1: ESC Electrical Connector & Air Line
    GM622089Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the electrical connector and air line if equipped with electronic suspension control (ESC).
  3. Support the rear axle.
    4. Fig 2: View Of Shock Absorber Upper & Lower Nuts & Bolts
    GM582394Courtesy of GENERAL MOTORS CORP.
  4. Remove the upper shock absorber nut and the bolt.
  5. Remove the lower shock absorber nut and the bolt.
  6. Remove the shock absorber.
scientia non olet · About LEMON Manuals