LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 158 (Rear Suspension System) >> Repair Instructions >> Shock Absorber Replacement (1500 Series) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Shock Absorber Upper & Lower Nuts & Bolts
    GM582394Courtesy of GENERAL MOTORS CORP.
  1. Install the shock absorber.
  2. Install the upper shock absorber nut and bolt.
    3. NOTE: Refer to Fastener Notice .
  3. Install the lower shock absorber nut and bolt.

    Tighten:  Tighten the upper and lower shock absorber nuts to 95 N.m (70 lb ft).

    4. Fig 2: ESC Electrical Connector & Air Line
    GM622089Courtesy of GENERAL MOTORS CORP.
  4. Connect the electrical connector and air line if equipped with the ESC.
  5. Remove the support from the rear axle.
  6. Remove the safety stands.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals