LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 158 (Rear Suspension System) >> Repair Instructions >> Rear Axle Upper Control Arm Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the electronic suspension control (ESC) sensor, if equipped. Refer to Rear Position Sensor Replacement - Electronic Suspension - Left or Rear Position Sensor Replacement - Electronic Suspension - Right .
    3. Fig 1: Upper Control Arm-To-Frame Bracket Retaining Nut And Bolt
    GM516277Courtesy of GENERAL MOTORS CORP.
  3. Remove the upper control arm retaining nut and bolt from the frame bracket.
    4. Fig 2: Upper Control Arm-To-Axle Bracket Retaining Nut And Bolt
    GM516271Courtesy of GENERAL MOTORS CORP.
  4. Remove the upper control arm retaining nut and bolt from the axle bracket.
  5. Remove the upper control arm.
scientia non olet · About LEMON Manuals