LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 158 (Rear Suspension System) >> Repair Instructions >> Rear Axle Upper Control Arm Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the upper control arm.
    2. Fig 1: Upper Control Arm-To-Axle Bracket Retaining Nut And Bolt
    GM516271Courtesy of GENERAL MOTORS CORP.
  2. Install the upper control arm retaining bolt and nut to the axle bracket.
    3. Fig 2: Upper Control Arm-To-Frame Bracket Retaining Nut And Bolt
    GM516277Courtesy of GENERAL MOTORS CORP.
  3. Install the upper control arm retaining bolt to the frame bracket.
    4. NOTE: Refer to Fastener Notice .
    IMPORTANT: Do not tighten the nuts unless the suspension is at the curb height position.
  4. Install the upper control arm retaining nut.

    Tighten:  Tighten the upper control arm retaining bolts to 160 N.m (118 lb ft).

  5. Connect the ESC sensor, if equipped. Refer to Rear Position Sensor Replacement - Electronic Suspension - Left or Rear Position Sensor Replacement - Electronic Suspension - Right .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals