LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 158 (Rear Suspension System) >> Repair Instructions >> Rear Axle Lower Control Arm Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Lower Control Arm, Retaining Nuts & Bolts
    GM545535Courtesy of GENERAL MOTORS CORP.
  1. Install the lower control arm.
  2. Install the lower control arm retaining bolts.
    3. NOTE: Refer to Fastener Notice .
    IMPORTANT: Do not tighten the bolts unless the suspension is at the ride height.
  3. Install the lower control arm retaining nut.

    Tighten: 

    • Tighten the lower control arm to frame bolts to 140 N.m (103 lb ft).
    • Tighten the lower control arm to axle bolts to 160 N.m (118 lb ft).

  4. Remove the rear axle support.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals