LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 157 (Steering Linkage) >> Repair Instructions >> Tie Rod Replacement - Inner >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Perform the following procedure before installing the new tie rod ends:
  1. Remove all traces of the oil, grease, or other contaminants.
  2. Clean the threads of the tie rod with denatured alcohol or the equivalent and allow to dry.
  3. Apply red LOCTITE™ threadlocker, GM P/N 12345493 (Canadian P/N 10953488) to the threads of the inner tie rod.
    4. Fig 1: View Of Inner Tie Rod End & J 34028
    GM865341Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  4. Install the inner tie rod to the relay rod.

    Tighten:  Using the J 34028  (2) tighten the tie rod to 100 N. See Special Tools .m (74 lb ft).

  5. Install the outer tie rod end. Refer to Tie Rod Replacement - Outer .
  6. Install the engine protection shield, if equipped. Refer to Engine Shield Replacement .
  7. Lower the vehicle.
  8. Verify the wheel alignment. Refer to Wheel Alignment Specifications .
scientia non olet · About LEMON Manuals