LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 157 (Steering Linkage) >> Repair Instructions >> Steering Damper Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Steering Damper & Components
    GM340952Courtesy of GENERAL MOTORS CORP.
  1. Raise the vehicle. Support the vehicle with safety stands. Refer to Lifting and Jacking the Vehicle .
  2. Remove the engine protection shield, if equipped. Refer to Engine Shield Replacement .
    3. IMPORTANT: Do not reuse the nut.
  3. Remove the steering damper (2) ball stud nut (1).
    4. Fig 2: View Of Steering Damper Ball Stud, Relay Rod & J 24319-B
    GM397364Courtesy of GENERAL MOTORS CORP.
  4. Remove the steering damper ball stud from the relay rod using the J 24319-B  .
    5. Fig 3: View Of Steering Damper & Components
    GM340952Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not reuse the nut.
  5. Remove the steering damper mounting bolt (5) and the nut (6).
  6. Remove the steering damper (4) from the vehicle.
  7. Inspect the following parts:
    • The steering damper for leaks and damage
    • The mounting bolts and the nuts for damage or corrosion
scientia non olet · About LEMON Manuals