LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 157 (Steering Linkage) >> Repair Instructions >> Steering Damper Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Steering Damper & Components
    GM340952Courtesy of GENERAL MOTORS CORP.
  1. Install the steering damper (4).
  2. Install the mounting bolt (5) and a new prevailing torque nut (6).
  3. Install the steering damper ball stud (2) to the relay rod (3).
    4. NOTE: Refer to Fastener Notice .
  4. Install the prevailing torque nuts.

    Tighten:  Tighten the steering damper mounting nuts to 40 N.m (30 lb ft).

  5. Install the engine protection shield, if equipped. Refer to Engine Shield Replacement .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals