LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 157 (Steering Linkage) >> Repair Instructions >> Idler Arm Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Do not attempt to free the ball stud by using a pickle fork or wedge type tool, because seal or bushing damage could result. Use the proper tool to separate all ball joints.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. Fig 1: View Of Relay Rod & Components
    GM340481Courtesy of GENERAL MOTORS CORP.
  2. Remove the engine protection shield, if equipped. Refer to Engine Shield Replacement .
  3. Remove the idler arm ball stud nut (10).

    Do not reuse the idler arm ball stud nut.

    4. Fig 2: View Of Outer Tie Rod Assembly & J 24319-B
    GM643351Courtesy of GENERAL MOTORS CORP.
  4. Remove the idler arm from the relay rod using the J 24319-B  .
    5. Fig 3: View Of Idler Arm, Frame Bolts & Nuts
    GM340442Courtesy of GENERAL MOTORS CORP.
  5. Remove the idler arm frame bolts (3) and the nuts (1).
  6. Remove the idler arm (2) from the vehicle.
scientia non olet · About LEMON Manuals