LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 156 (Transfer Case - BW 4485-Nr3 AWD) >> Repair Instructions >> Transfer Case Output Shaft Seal Replacement - Rear >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Cadillac Escalade EXT, 2007 Cadillac Escalade ESV, and 2007 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing Rear Output Shaft Seal With Flathead Screwdriver
    GM1728918Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
  3. Remove the rear propeller shaft. Refer to Rear Propeller Shaft Replacement .
  4. Remove the rear output shaft seal by prying it out with a flat tipped screwdriver.
scientia non olet · About LEMON Manuals