Indexing Torque Converter

WARNING: This page is about a different car, the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Cadillac Escalade EXT, 2007 Cadillac Escalade ESV, and 2007 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.

To determine and correct a torque converter vibration, the following procedure may have to be performed several times to achieve the best possible torque converter to flywheel balance.

Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
Rotate the torque converter one bolt position.

Fig 1: View Of Torque Converter Hub In Engine Crankshaft

Courtesy of GENERAL MOTORS CORP.

Align the torque converter hub (2) in the engine crankshaft (3) and install the torque converter to flywheel bolts.
Lower the vehicle.
With the engine at idle speed and the transmission in PARK or NEUTRAL, observe the vibration. Refer to Noise and Vibration Analysis .
Repeat this procedure until you obtain the best possible balance.
Install the transmission converter cover bolts and the cover.