Automatic Transmission Oil Cooler Flushing and Flow Test (J 45096): Clean-up
WARNING: This page is about a different car, the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Cadillac Escalade EXT, 2007 Cadillac Escalade ESV, and 2007 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
- Turn the main function switch (2) to the IDLE position and allow the supply vessel pressure to dissipate.
- Turn the main power switch (1) to the OFF position.
- Disconnect the supply and waste hoses and the 12-volt power source from the vehicle.
- Disconnect the air supply hose from J 45096 .
- Dispose of the waste ATF in accordance with all applicable federal, state, and local requirements.
IMPORTANT:
A small amount of water may drain from the bottom of the unit when the air supply is disconnected. This is a normal operation of the built-in water separator.