Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Floor Panel Exhaust Heat Shield Nuts & Heat Shield

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Position the rear floor panel exhaust heat shield to the studs and install the heat shield nuts.
Tighten: Tighten the nuts to 9 N.m (80 lb in).

Fig 2: View Of Floor Panel Exhaust Heat Shield Nuts & Heat Shields

Courtesy of GENERAL MOTORS CORP.

If the vehicle is a Suburban, Yukon XL, Yukon Denali XL, Escalade ESV, Escalade EXT or a Avalanche, position the exhaust heat shield to the studs and install the heat shield nuts, as required.
Tighten: Tighten the nuts to 9 N.m (80 lb in).

Fig 3: View Of Floor Panel Exhaust Heat Shield Nuts & Heat Shields

Courtesy of GENERAL MOTORS CORP.

If the vehicle is a Tahoe, Yukon, Yukon Denali, or a Escalade, position the exhaust heat shield to the studs and install the heat shield nuts, as required.
Tighten: Tighten the nuts to 9 N.m (80 lb in).

Fig 4: View Of Left Front Floor Panel Exhaust Heat Shield Nuts & Heat Shield

Courtesy of GENERAL MOTORS CORP.

Position the left front floor panel exhaust heat shield to the studs and install the heat shield nuts.
Tighten: Tighten the nuts to 9 N.m (80 lb in).
Install the muffler assembly, as required. Refer to Muffler Replacement (1500 - w/RPO L92) or Muffler Replacement (1500 - w/RPOs LC9/LMG/LY5/L76) or Muffler Replacement (1500 - w/RPOs LMG/LY2/LY5) or Muffler Replacement (2500) .
Install the catalytic converter, if necessary. Refer to one of the following: