LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 150 (Propeller Shaft And Universal Joints) >> Diagnostic Information and Procedures >> Ping, Snap, or Click Noise

Ping, Snap, or Click Noise

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Ping, Snap, or Click Noise

Checks Action
DEFINITION: A ping, snap or click is usually heard on initial load after the transmission is in gear, either in forward or reverse.
The fixed yoke or the pinion yoke is loose. Tighten the bolts and the pinion nut to specified torque. Refer to Fastener Tightening Specifications .
One or more of the universal joints are worn or damaged. Replace the universal joint. Refer to the following:
scientia non olet · About LEMON Manuals