LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 150 (Propeller Shaft And Universal Joints) >> Diagnostic Information and Procedures >> Knock or Clunk Noise

Knock or Clunk Noise

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Knock or Clunk Noise

Checks Action
DEFINITION: Knocking or clunking noise occurs when operating the vehicle in high gear or coasting in neutral at 16 km/h (10 mph).
One or more of the universal joints are worn or damaged. Replace the universal joint. Refer to the following:
The side gear hub counterbore in the differential is worn oversize. Replace the differential case and/or the side gears. Refer to Differential Replacement or Differential Replacement (11.0 inch Axle) in Rear Drive Axle.
scientia non olet · About LEMON Manuals