LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Displays And Gages) >> Repair Instructions >> Instrument Cluster Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: The ignition switch must be in the OFF position when removing the instrument panel (I/P) cluster.
    Fig 1: I/P Cluster Trim Panel Screws
    GM815927Courtesy of GENERAL MOTORS CORP.
  1. Remove the I/P cluster trim plate from the instrument panel. Refer to Instrument Cluster Trim Panel Replacement .
  2. Remove the screws from the I/P cluster to instrument panel.
    3. Fig 2: I/P Cluster
    GM816330Courtesy of GENERAL MOTORS CORP.
  3. Remove the I/P cluster from the instrument panel.
    4. Fig 3: I/P Cluster Electrical Connections
    GM816329Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the I/P cluster electrical connections.
scientia non olet · About LEMON Manuals