Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: I/P Cluster Electrical Connections

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connections to the cluster.
Position the I/P cluster to the instrument panel.

Fig 2: I/P Cluster

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the screws to the instrument panel cluster.
Tighten: Tighten the screws to 2 N.m (18 lb in).

Fig 3: I/P Cluster Trim Panel Screws

Courtesy of GENERAL MOTORS CORP.

Install the instrument cluster trim plate. Refer to Instrument Cluster Trim Panel Replacement .
When the I/P cluster is replaced the new I/P cluster will need to be programmed. Refer to Instrument Cluster Programming and Setup .