Tachometer Inaccurate or Inoperative
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
Tachometer Inaccurate or Inoperative
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Instrument Cluster Schematics Connector End View Reference: Displays and Gauges Connector End Views |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 |
|
Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 |
| 3 | Test the engine speed signal circuit for a high resistance between the instrument panel cluster (IPC) and powertrain control module (PCM). Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
Go to Step 6 | Go to Step 4 |
| 4 | Inspect for poor connections at the harness connector of the instrument cluster. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
. Did you find and correct the condition? |
Go to Step 6 | Go to Step 5 |
| 5 | Replace the IPC. Refer to Control Module References
for replacement, setup, and programming. Did you complete the replacement? |
Go to Step 6 | - |
| 6 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |