Conditions for Clearing the DTC

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

The history DTC clears after 100 malfunction free warm-up cycles.
The DTC becomes history when the conditions for setting the DTC are no longer present.
The IPC receives the clear code command from the scan tool.

DTC B0540

Step	Action	Yes	No
Schematic Reference: Instrument Cluster Schematics
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle
2	Install a scan tool. Raise the vehicle's drive wheels. Refer to Lifting and Jacking the Vehicle . Start the engine. Place the transmission into drive for an automatic transmission and third gear for a manual transmission. With the scan tool, observe the Vehicle Speed Sensor parameter in the PCM Engine Data 1 data list. Does the Vehicle Speed Sensor parameter match the speedometer display?	Go to Testing for Intermittent Conditions and Poor Connections	Go to Step 3
3	Turn the ignition OFF. Disconnect the powertrain control module (PCM) connector C2. Install the J 33431-C Signal Generator and Instrument Panel Tester lead to the vehicle speed signal circuit at the PCM harness connector, and the other lead to a good ground. Turn the ignition ON, with the engine OFF. Set the J 33431-C to generate a speedometer signal. Does the vehicle speedometer indicate a reading?	Go to Step 5	Go to Step 4
4	Test the vehicle speed signal circuit for an open, short to voltage or a short to ground. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition?	Go to Step 9	Go to Step 6
5	Inspect for poor connections at the PCM connector. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition?	Go to Step 9	Go to Step 7
6	Inspect for a poor connection at the harness connector of the instrument panel cluster (IPC). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition?	Go to Step 9	Go to Step 8
7	Replace the PCM. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement?	Go to Step 9	-
8	Replace the IPC. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement?	Go to Step 9	-
9	Use the scan tool in order to clear the DTCs. Operate vehicle within the conditions for running this DTC as specified in the supporting text. Does the DTC reset?	Go to Step 2	System OK