LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Displays And Gages) >> Diagnostic Information and Procedures >> Chime Inoperative

Chime Inoperative

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
Chime Inoperative

Step Action Yes No
Schematic Reference: Audible Warnings Schematics 
DEFINITION: One or more chime functions are inoperative.
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle
2
  1. Turn the ignition OFF, with the key in the ignition.
  2. Open the driver door.
Does the chime sound?		 Go to Testing for Intermittent Conditions and Poor Connections Go to Step 3 
3 Do the courtesy lights turn on when you open the driver door? Go to Step 4  Go to Courtesy Lamps Inoperative
4
  1. Turn the ignition ON, with the engine OFF.
  2. Turn the radio ON.
  3. Adjust the radio balance and fade to the left front speaker.
Does the speaker operate properly?		 Go to Step 5  Go to Speakers Inoperative - One or More
5 Replace the radio. Refer to Control Module References for replacement, setup, and programming.
Did you complete the replacement?		 Go to Step 6  -
6 Operate the system in order to verify the repair.
Did you correct the condition?		 System OK Go to Step 1 
scientia non olet · About LEMON Manuals