LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 145 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L And 6.2L - DTC P0335 To DTC P3449) >> DTC P0685, P0689, or P0690 >> Component Testing

Component Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the powertrain relay.
  2. Test for 65-110 ohms of resistance between terminals 85 and 86 of the relay.
    • If the resistance is not within the specified range, replace the relay.
  3. Test for infinite resistance between the following terminals:
    • Terminal 30 and 86
    • Terminal 30 and 87
    • Terminal 30 and 85
    • Terminal 85 and 87
    • If not the specified value, replace the relay.
  4. Install a 20A fused jumper wire between relay terminal 85 and 12 volts. Install a jumper wire between relay terminal 86 and ground. Test for less than 1 ohm of resistance between terminals 30 and 87.
    • If greater than the specified range, replace the relay.
scientia non olet · About LEMON Manuals