LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 141 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L And 6.2L - DTC P0010 To DTC P0333) >> DTC P0315 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: The CKP System Variation Learn Procedure may have to be repeated up to 5 times before the procedure is learned.
  1. Perform the CKP System Variation Learn Procedure. Refer to Crankshaft Position System Variation Learn .
  2. If the CKP System Variation Learn Procedure cannot be performed successfully, inspect for the following conditions:
    • Any worn crankshaft main bearings
    • A damaged or misaligned reluctor wheel
    • Excessive crankshaft runout
    • A damaged crankshaft-Refer to Crankshaft and Bearings Cleaning and Inspection .
    • Interference in the signal circuit of the CKP sensor
    • The ignition switch is left in the ON position, until the battery is discharged
    • An ECM power disconnect, with the ignition ON, that may have erased the CKP system variation values and set DTC P0315
    • Any debris between the CKP sensor and the reluctor wheel
    • If the ECM is unable to complete the learn procedure, replace the ECM.
scientia non olet · About LEMON Manuals