LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 141 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L And 6.2L - DTC P0010 To DTC P0333) >> DTC P0120, P0122, P0123, P0220, P0222, P0223, or P2135 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, observe the scan tool TP sensor 1 voltage parameter. The reading should be between 4.75-0.33 volts and change with accelerator pedal input.
  2. Ignition ON, observe the scan tool TP sensor 2 voltage parameter. The reading should be between 0.25-4.59 volts and change with accelerator pedal input.
  3. Ignition ON, observe the scan tool TP sensor 1 and 2 parameter. The scan tool should indicate agree.
  4. Clear the DTCs with the scan tool. Operate the vehicle within the Conditions for Running the DTC, or within the conditions that you observed from the Freeze Frame/Failure Records.
  5. Verify that DTC P0120 or P0220 are not the only throttle position DTCs set.
    • If DTC P0120 or P0220 are the only DTCs set, replace the control module.
  6. Verify that DTCs P0641 or P0651 are not set.
scientia non olet · About LEMON Manuals