Conditions for Setting the DTC: P0010

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

The ECM detects that the state of the high side driver and the state of the CMP solenoid control circuit does not match. The ECM will detect an open, high resistance, short to ground, or a short to voltage on the CMP solenoid control circuit, or an open on the low reference circuit, if the condition is present for more than 6 seconds.

P0011

The ECM detects resistance greater than 2 ohms on the low reference circuit.
The ECM detects that the CMP Angle position is more than 8 degrees difference than the Desired CMP position.