Conditions for Running the DTC

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

P0010

The ignition switch is in the crank or run position.
The system voltage is between 9-18 volts.
The CMP actuator is command ON.
DTC P0010 runs continuously when the above conditions are met.

P0011

DTC P0010, P0016, P0335, P0336, P0340, or P0341 is not set.
The engine is running.
The system voltage is between 9-18 volts.
The CMP actuator is enabled.
The power take off (PTO) is not active.
The rate of change in the camshaft position is less than 7.5 degrees for 3.35 seconds.