LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Suspension Control System - Suspension Leveling) >> Repair Instructions >> Air Compressor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    2. Fig 1: Air Tube At Air Dryer & Electrical Connection
    GM657695Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Clean the components and the surrounding area to prevent dirt from entering the air system before disconnecting the air hose from the air compressor.
  2. Disconnect the air tube (1) from the air dryer.
  3. Disconnect the electrical connection (2).
    4. Fig 2: Air Compressor & Air Inlet Hose
    GM657691Courtesy of GENERAL MOTORS CORP.
  4. Remove the air inlet and hose (1) from the fuel filler neck bracket.
  5. Loosen the mounting nuts.
  6. Slide the air compressor (2) rearward to clear the frame slots.
  7. Remove the air compressor from the vehicle.
scientia non olet · About LEMON Manuals