Repair Verification

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Install any components or connectors that have been removed or replaced during diagnosis.
Perform any adjustment, programming or setup procedures that are required when a component or module is removed or replaced.
Clear the DTCs.
Use the scan tool Diagnostic Counter Reset output control function to bypass the 3 consecutive ignition cycle requirement for setting a DTC. This will ensure that if a DTC was to be reset during the repair verification process, it will be displayed on the scan tool.
Turn OFF the ignition for 60 seconds.
Turn ON the ignition.
If the repair was related to a DTC, duplicate the Conditions for Running the DTC and use the Freeze Frame/Failure Records, if applicable, in order to verify the DTC does not reset. If the DTC resets or another DTC is present, refer to the DIAGNOSTIC CODE INDEX and perform the appropriate diagnostic procedure.