LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Steering Wheel And Column) >> Repair Instructions >> Turn Signal Multifunction Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Turn Signal Switch Assembly
    GM761439Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to SIR Caution .
  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Remove the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement .
  3. Tilt the column to the CENTER position.
  4. Disconnect the connectors from the turn signal and multifunction switch assembly.
  5. Remove the turn signal and multifunction switch assembly.
  6. Remove 2 pan head tapping screws from the turn signal and multifunction switch assembly.
scientia non olet · About LEMON Manuals