LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Steering Wheel And Column) >> Repair Instructions >> Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Depressing Lock Plate Using J 23653-SIR And J 42137
    GM371185Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to SIR Caution .
  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Remove the SIR coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement .
  3. Remove and discard the bearing retainer using J 23653-SIR  and J 42137  . See Special Tools .
  4. Remove J 23653-SIR  and J 42137  from the steering shaft. See Special Tools .
    5. Fig 2: View Of Turn Signal Cancel Cam, Upper Bearing Inner Race & Components
    GM761443Courtesy of GENERAL MOTORS CORP.
  5. Remove the shaft lock (2) or the cam orientation plate (1).
    6. IMPORTANT: Do not wipe the lubricant off the turn signal cancel cam assembly.
  6. Remove the turn signal cancel cam assembly (3).
  7. Remove the upper bearing spring (4).
  8. Remove the upper bearing inner race seat (5).
  9. Remove the inner race (6).
scientia non olet · About LEMON Manuals