Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Electric Park Lock & Ignition Lock Cylinder Case Assembly

Courtesy of GENERAL MOTORS CORP.

Snap the electric park lock (2) onto the ignition lock cylinder case assembly (1).

Fig 2: Electric Park Lock & Connector

Courtesy of GENERAL MOTORS CORP.

CAUTION: Improper routing of the wire harness assembly may damage the inflatable restraint steering wheel module coil. This may result in a malfunction of the coil, which may cause personal injury.

Reconnect the connector (2) to the electric park lock (1).
Install the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement .
Enable the SIR system. Refer to SIR Disabling and Enabling .