LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Steering Wheel And Column) >> Repair Instructions >> Steering Column Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Upper Intermediate Shaft Boot
    GM793261Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the steering column seal.

    Tighten:  Tighten the upper intermediate shaft to boot nuts to 50 N.m (37 lb ft).

    2. Fig 2: Upper Intermediate Shaft & Lower Intermediate Shaft
    GM793256Courtesy of GENERAL MOTORS CORP.
  2. Install the steering column seal nuts.

    Tighten  Tighten the nuts to 3 N.m (27 lb in).

  3. Connect the upper intermediate shaft to the lower intermediate shaft.
  4. Install the upper intermediate shaft to the lower intermediate shaft pinch bolt.

    Tighten:  Tighten the upper intermediate shaft pinch bolt to 50 N.m (37 lb ft).

    5. Fig 3: Identifying J 42640
    GM333146Courtesy of GENERAL MOTORS CORP.
  5. Unlock the steering column by removing J 42640  from the steering column lower trim cover access hole.
scientia non olet · About LEMON Manuals