Input and Output Speed Sensor Replacement

WARNING: This page is about a different car, the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Cadillac Escalade EXT, 2007 Cadillac Escalade ESV, and 2007 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Input and Output Speed Sensor

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the transmission fluid pan and filter. Refer to Automatic Transmission Fluid, Fluid Pan and/or Filter Replacement . Remove the upper and lower valve body assembly. Refer to Control Valve Lower Body and Upper Body Replacement .
1	Speed Sensor Electrical Connector
2	Input and Output Speed Sensor Assembly Bolts (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 12 N.m (106 lb in)
3	Input and Output Speed Sensor Assembly Clips (Qty: 2) Tip: Inspect the wiring harness clips for damage replace if necessary.
4	Input and Output Speed Sensor Assembly