Torque Converter Removal and Holding Fixture Installation

WARNING: This page is about a different car, the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Cadillac Escalade EXT, 2007 Cadillac Escalade ESV, and 2007 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Torque Converter And Holding Fixture Component View

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Torque Converter Assembly
2	Transmission Case Assembly Tip: Rotate the transmission so that the converter housing is up and secure with locking pin. Allow any remaining transmission fluid to drain from the case extension. Special Tools DT 47605 Holding Fixture Adapter. See Special Tools . J 3289-20 Holding Fixture Base Assembly J 8763-B Holding Fixture. See Special Tools .
3	Locking Pin Tip: Rotate the transmission so that the converter housing is up and secure with locking pin. Allow any remaining transmission fluid to drain from the case extension.

Callout

Component Name

Torque Converter Assembly

Transmission Case Assembly
Tip:

Rotate the transmission so that the converter housing is up and secure with locking pin.
Allow any remaining transmission fluid to drain from the case extension.

Special Tools

DT 47605 Holding Fixture Adapter. See Special Tools .
J 3289-20 Holding Fixture Base Assembly
J 8763-B Holding Fixture. See Special Tools .

Locking Pin
Tip:

Rotate the transmission so that the converter housing is up and secure with locking pin.
Allow any remaining transmission fluid to drain from the case extension.